The Fabric at a Glance

The reference item is DD2305037-2. The supplier lists it as an 80/20 cotton-linen terry knit with a looped surface. The figures below come from the supplier's product page.

Why 130 g/㎡ Matters More Than the Word "Terry"

The word terry makes many people think of bath towels, which are much heavier than this fabric. At 130 g/㎡ the loops are small and the cloth stays light and flexible. Think of it as an apparel terry: it absorbs moisture, feels textured against the skin and does not weigh the wearer down. That is the main reason it fits T-shirts, light tops and summer loungewear better than robes or towels.

A light terry also behaves differently in production. It is less bulky at seams and hems, so it sews more cleanly than a heavy loop knit. The trade-off is that the loops have less cushion, so check how the surface looks after repeated washing before you commit to a large order.

What the 20% Linen Actually Changes

Twenty percent is a measured dose. It is enough for a visibly natural, slightly uneven surface and a drier feel than pure cotton, but not enough to make the fabric stiff or heavily wrinkled the way a 100% linen cloth can be. The supplier's own technical notes describe the linen as adding durability and breathability while cotton supplies softness. Buyers should still expect some creasing, since linen is the fibre most associated with it.

If you want a stronger linen character, compare it with the supplier's 55/45 linen cotton single jersey (185 g/㎡, 138 cm wide). If you want a heavier loop, look at the cotton polyester linen terry, which is listed at 355 g/㎡. The table below puts these options side by side.

You can browse the full range, including the 100% linen single jersey, in the supplier's linen, hemp and blends category.

Where It Works Best

The supplier lists casualwear, loungewear and activewear, children's clothing, and resort and beachwear as target uses. Based on the weight and fibre mix, here is how I would rank them for a first sample run.

Known Issues and How to Manage Them

The supplier names three common issues openly: shrinkage after the first wash, minor pilling with extended wear, and wrinkling. That honesty is useful, because each one can be controlled if you plan for it.

Shrinkage. Ask for dimensional change results on the finished fabric, and wash a sample garment in your own factory the way a consumer would. Cut patterns with the measured shrinkage included rather than relying on a general allowance.

Pilling. Loop surfaces with fine yarns can fuzz at points of friction. Ask which pilling test method the supplier uses and request a grade in writing. The supplier's capability page states that it has a pilling testing machine, an anti-yellowing tester and a rubbing testing machine.

Wrinkling. Do not try to eliminate it. Design for it: choose relaxed silhouettes, and give customers clear care instructions. Gentle steaming works better than hard ironing on a looped surface.

Care Guidance for Your Label

The supplier recommends machine washing in cold or lukewarm water on a gentle cycle, drying flat or on low heat, avoiding bleach, and ironing on low heat with steam if needed. These instructions are sensible for natural-fibre knits. Confirm the final label wording with your own wash testing, since your trims, prints and dyes can change the result.

A Practical Checklist Before You Order